I can not install dcm-1270 in the winxp
After i set the irq and i/o address still can not connet with controller The driver is glwdmisa.sys ver 7.0.17.0
There is a error code 10 in the system device , what can i do?
Comments 1
AndrewS on
04/11/2017 - 08:45
Hi buoyage,
I have several follow-up questions. It would be best to follow-up over email. Please reply to support@galil.com and add "Forward to Andrew" in your response.
Include the serial number for the DMC-1270.
Can you describe more about your system?
With an older legacy controller, when was it working? Is this just a new PC? What was the previous Operating System?
What Galil software are you using and getting the error in?
Is the error 10 or -10? Is the error thrown by the Galil Software or the Device Manager?
AndrewS on 04/11/2017 - 08:45
Hi buoyage,
I have several follow-up questions. It would be best to follow-up over email. Please reply to support@galil.com and add "Forward to Andrew" in your response.
Include the serial number for the DMC-1270.
Can you describe more about your system?
With an older legacy controller, when was it working? Is this just a new PC? What was the previous Operating System?
What Galil software are you using and getting the error in?
Is the error 10 or -10? Is the error thrown by the Galil Software or the Device Manager?
Regards,
Andrew