Skip to main content
Submitted by kmulleners on Mon, 05/07/2018 - 05:53

Were are trying to use the SB and CB commands to create a TTL output pulse as a trigger to a external system with the DMC30017 HSRC. We have tried to wire everything up as suggested in the manual but we do not get any output signal. Any suggestions are highly appreciated.

Comments 1

KushalP on 09/10/2018 - 15:29

This was resolved via a support call into Galil. If there is still an issue please call into Galil or send an email to support at galil dot com.