Skip to main content
Submitted by Ben Doyle on Wed, 05/03/2017 - 11:58

Hello, am trying to figure out how my VB.net application can both read the state of the inputs on my DMC, and write to the outputs.

I have downloaded and fiddled around with GalilWidgets and I have no clue how to understand the xml, and the documentation is not very well written.

Any help would be great.
Thanks in advance.

Comments 1

KushalP on 05/17/2017 - 11:25

Hi Ben,

This should be posted in the Host Programming section, however I can address this. If you are trying to set I/O points you can do this using the GWTerm tool. The GWTerm tool allows you to send DMC commands directly to your controller. Refer to the source documentation that is included with Galil Widgets. To see the status of your IO points you can use the GW Poll tool.

Which controller are you trying to use Galil Widgets with?