I find now that time scaling of scope isn't correct, i.e. differs from real physical time. For example PTP time that is really takes 200ms the scope shown 2ms only. :confused:
But I've seen correct time scaling with the same CDS and the same PC few days ago.
What will be possible reason for such trouble?
I'll send screen snapshot to AndyH today later.
Galil_DJR on 01/09/2012 - 09:33
Try to reconnect to the CDS. If you change TM while connected, you must reconnect for the software to "see" this change.
LeGa on 01/09/2012 - 11:17
I didn't change TM. I have try to reconnect to CDS, restart PC, change CDS to another one, re-install GalilTools...but still without success.
Have you seen my snapshot sent to Andy and Kaushal?
Galil_DJR on 01/09/2012 - 16:07
Check in the Watch window for the Source "TIME"
Is the scale column 1?
Ensure that scale is 1 and Offset is 0
LeGa on 01/10/2012 - 00:01
OK!
It was another "TIME" scaling factor really, i.e. 64 instead 1.
Thank you very much!
But cursors must shown correct time for any TIME factor! :o
Please add such "scope time scaling" feature - after dedugging - to Scope Manual also.