Skip to main content
Submitted by CRAZYRICH on Wed, 01/28/2009 - 22:53

I have tried a firmware install on the DMC-1800 and used the 1.0 version and get a -1 failure..... when I jumper the UPGRD pins and reinstall the card and restart the computer I get the red LED lit on the back of the card. Any ideas?

Comments 1

Galil_AndyH on 01/29/2009 - 08:52

Have you tried re-installing the firmware after you restarted the PC? The UPGRD jumper puts the controller in "Monitor Mode", in this case the error LED will be illuminated until firmware has been downloaded to the controller correctly.

Also, what version of firmware did you originally have on your controller, and what version of firmware did you try and load? The firmware version should be 1.0 then a letter (ie 1.0p). Make sure that you are not upgrading from a version of firmware that is incompatible with your controller. See the Optima Series Standard Firmware section on the firmware downloads page.
http://www.galilmc.com/support/firmware-downloads.php