Print out Settings

Submitted by samf48 on Fri, 08/20/2010 - 11:33

Does anybody know of a way to display or print out all the available settings (YC,YA, AG, AU, etc...) of a DMC-4040 controller within GalilTools? I would like to see what settings exist in the controller before changing them. I know I can interrogate settings one by one but I was just curious if there is a command are way to view settings within the terminal.

Comments 2

Galil_DJR on 08/24/2010 - 09:21

I've written a backup application for Windows that you can try (40x0 and 21x3 supported at the moment). Note this is research-only/non-official. Contact me directly with any questions/comments.

djr at galilmc.com

http://www.galilmc.com/ftp/pub/.djr/.beta/.backup/

samf48 on 09/16/2010 - 09:58

Thanks DJ, I was just now able to test this and it's exactly what was needed, good work.

Since our introduction of the first microprocessor-based motion controller in 1983, Galil has remained a leading innovator. By offering our customers powerful, cost-effective and simple-to-use motion controllers and PLCs backed by superior application support, our commitment is to be the primary source for any motion control and I/O application.

Address:  270 Technology Way, Rocklin, CA 95765

Toll-Free:  (800) 377-6329 (US Only)

Phone:  (916) 626-0101

Fax:  (916) 626-0102

Email:  support@galil.com

2020 © Galil All Rights Reserved.