i tried to install the driver of the galil tools for a card DMC-18x2 PCI, and when it finishes the update of the controller , shows a message where says that the device cannot initiate error code 10,tried restart the system and reinstall several times without success,
Galil_AndyH on 04/29/2010 - 09:00
What is the hardware version of your DMC-18x2? You will need to remove the controller from the PC in order to find this information.
Forty on 04/29/2010 - 19:55
DMC-1842 Rev. C and a serial n� *AM12396*
Galil_AndyH on 04/30/2010 - 08:34
GalilTools only supports Rev D and newer DMC-18x2 controllers.
See Supported Controllers on http://www.galilmc.com/products/galiltools.php