How to read analog input resolution?

Submitted by himmetgencer on Tue, 05/03/2016 - 01:28

Hi everyone,

I've coded to general purpose data acquisition using Galil Motion Controllers, so I want to read analog input resolution from any Galil Motion controllers.

How to read analog input resolution programmatically ? (12-or 16 bit)

Thanks for answer...

Comments 1

troym_galil on 08/19/2016 - 09:58

It depends which controller you are using but if you would like to detect what hardware you have, check out the ID command.
Thanks,

Since our introduction of the first microprocessor-based motion controller in 1983, Galil has remained a leading innovator. By offering our customers powerful, cost-effective and simple-to-use motion controllers and PLCs backed by superior application support, our commitment is to be the primary source for any motion control and I/O application.

Address:  270 Technology Way, Rocklin, CA 95765

Toll-Free:  (800) 377-6329 (US Only)

Phone:  (916) 626-0101

Fax:  (916) 626-0102

Email:  support@galil.com

2020 © Galil All Rights Reserved.