Velocity vs Torque Mode

Submitted by Tsang on Wed, 02/21/2007 - 00:03

Could you list out what are the advantages and disadvantages of Velocity and Torque Mode? Which one is better for CNC Milling Machine?

If Velocity Mode is good for CNC Milling Machine, then there is no need to have the Torque Mode developed. It seems that there were something Torque Mode is better than Velocity.

Thanks so much

Tim

Comments 1

LeGa on 02/21/2008 - 01:03

Tim,
pay attention that you need as a rule internal Torque mode for Velocity mode also.

Since our introduction of the first microprocessor-based motion controller in 1983, Galil has remained a leading innovator. By offering our customers powerful, cost-effective and simple-to-use motion controllers and PLCs backed by superior application support, our commitment is to be the primary source for any motion control and I/O application.

Address:  270 Technology Way, Rocklin, CA 95765

Toll-Free:  (800) 377-6329 (US Only)

Phone:  (916) 626-0101

Fax:  (916) 626-0102

Email:  support@galil.com

2020 © Galil All Rights Reserved.