Dual Motors on Single Axis

Forums - Galil: We Move The World

You are not logged in. [Log In] Galil Motion Control » Forums » General Discussion » Tuning » Dual Motors on Single Axis

Page 2 of 2

Topic Options

#10877 - 05/16/11 08:41 PM Re: Dual Motors on Single Axis [Re: brplatz]
AndyH Member Registered: 12/20/05 Posts: 582 Loc: Rocklin, CA	Brian, Go ahead and e-mail support@galilmc.com and we will work with you directly. _________________________ Andy Herum Senior Applications Engineer Galil Motion Control
Top

Page 2 of 2

Previous Topic

Index

Next Topic

Moderator: AndyH

Galil

We move the world

OUR PRODUCTS
LEARNING CENTER
SUPPORT & DOWNLOADS
ABOUT GALIL
LOG IN
CONTACT
PRIVACY
SITE MAP

Since our introduction of the first microprocessor-based motion controller in 1983, Galil has remained the industry's leading innovator. By offering our customers the most powerful, cost-effective and simple-to-use motion controllers available today, our commitment is to be your primary source for any motion control application.