Galil command box

GALIL Cmd - Galil command box

Symbol:

Description:
Sends valid Galil command to controller. The command will be sent on every scan that the rung evaluates TRUE therefore the user should take care in what command is being output. If an MG command is used, this will send messages out the communications port and could slow down scan times (especially when using RS-232). A PD (Positive Differential) output should be used in conjunction with this box to only have the command run one time.

Range:

Cmd is any valid Galil command

Memory Map

Type: Boxes (Special)

Example Ladder Program:

GalilTools Scope Output: