ICS-48100 100pin adapter for DMC-40×0 Motion Controller
Posted on July 1st, 2008 by John Hayes at GalilPosted in Motion Controllers |
The ICS-48100 is a breakout module that plugs directly into the D-sub connectors of the DMC-40×0 motion controller and converts them into a 100pin Connector. This is especially useful for those that would like to upgrade to the DMC-40×0 series from a motion controller with a 100pin cable (such as the DMC-22×0 or DMC-18xx series) but do not want to change their wiring. This interconnect board will allow users to keep their existing 100 pin cable & interconnect module the same.
For complete details, go to Application Note #2511 located here:
http://www.galilmc.com/support/appnotes/accelera/note2511.pdf