Hi. I'm new to this and I'm trying to interface a force signal (generated by a sensor and then signal conditioned) to the Galil to control motor speed. I have a Galil DMC-2123 with ICM-20100 and DB-28040. Does the input signal get connected to J3 on the DB-28040? Can I use any ground pinon J3? Do J3 pins 13 - 15 require the indicated voltages or are they outputs?
Next, on the ICM-20100 is there a detailed description of the pinouts for J3-J6? I don't understand what each pin represents.
Lastly, is an axis a term for motor?
Thanks for any help.
GlenG on 05/03/2006 - 13:54
Mark,
Please read the following documentation:
Chapters 1-3,6,& 7 in the User Manual: [url=http://www.galilmc.com/support/manuals/man21x2.pdf]www.galilmc.com/supp…]
(reference the Command Reference for command explanations)
The ICM-20100 and DB-28040 sections of the DMC-21x3 Accessories Manual:
http://www.galilmc.com/support/manuals/21x3_accessories.pdf
Application Note 2419, 2428 here:
[url=http://www.galilmc.com/literature/technotes.html]www.galilmc.com/litera…]
MarkL on 05/03/2006 - 15:28
Thanks Glen.
Thanks also to Karl R. who gave me excellent phone support today.
Once the hardware is finished wiring today or tomorrow morning I may have some software questions.
thanks again,
Mark.
GlenG on 05/03/2006 - 15:42
No Prob,
I realize it's a decent qty of reading, but it goes fast and it's all necessary for getting up to speed.
farouq.alomari on 11/06/2017 - 00:41
i'm using galil control system in an accelerator and i'm doing some practices on it