DMC 630 not connect to smart term

Submitted by william valentini on Thu, 09/22/2016 - 13:27

Hi, I can not connect with the old term smart controller dmc 630 isa, the program returns me error in the failure to load the card's driver. In the selection of smart devices in term is not present dmc 630. How can I do?
Thank you.
William.

Comments 1

AndrewS on 12/20/2016 - 08:47

Hi William,
Can you either send me an email or give a call regarding this? Please email support@galil.com and include "Please forward to Andrew" at the top. Or you can call in and ask for me.

Please include serial number, the operating system, screenshots showing the error, and also a description of when the controller was working to now.

Regards,
Andrew

Since our introduction of the first microprocessor-based motion controller in 1983, Galil has remained a leading innovator. By offering our customers powerful, cost-effective and simple-to-use motion controllers and PLCs backed by superior application support, our commitment is to be the primary source for any motion control and I/O application.

Address:  270 Technology Way, Rocklin, CA 95765

Toll-Free:  (800) 377-6329 (US Only)

Phone:  (916) 626-0101

Fax:  (916) 626-0102

Email:  support@galil.com

2020 © Galil All Rights Reserved.