Changing IP address using GalilTools v1.4

Submitted by lightdee on Mon, 07/27/2009 - 12:58

I'm using GalilTools v1.4 and am connecting to a DMC2142s.

With the old terminal program, I was able to change the IP address after connecting to this controller, but I can't figure out how to do this operation using GalilTools - it already has an IP address & I want to assign it a different IP address.

Comments 2

Galil_DJR on 07/27/2009 - 13:03

An example should make it easy:

If you wanted to change the IP address to 192.168.1.100, just type into the terminal:

IA192,168,1,100;BN

Then type enter. You will get a timeout because the IP address is changed. Click the plus icon to connect to the reassigned controller.

lightdee on 07/27/2009 - 14:33

Thanks - that worked. It would be a nice feature to add to GalilTools.

Since our introduction of the first microprocessor-based motion controller in 1983, Galil has remained a leading innovator. By offering our customers powerful, cost-effective and simple-to-use motion controllers and PLCs backed by superior application support, our commitment is to be the primary source for any motion control and I/O application.

Address:  270 Technology Way, Rocklin, CA 95765

Toll-Free:  (800) 377-6329 (US Only)

Phone:  (916) 626-0101

Fax:  (916) 626-0102

Email:  support@galil.com

2020 © Galil All Rights Reserved.