migration from XP to W7 for LabView

Submitted by Tonio on Mon, 08/19/2013 - 23:39

Hello,

We have made some application with LabView 8.6 with XP some years ago they are still working properly ! Now it's time to migrate to W7 and LabView 2010. I have installed a 6/11 version of the tool kit and it becomes impossible to communicate (ethernet) with the controlers
GALDMC-2123-D-C24 but I can send commands through the WSDK and terminal.
Must I have a most recent version of the toolkit for LabView 2010 ?

Thank's in advance

Tonio

Comments 1

Galil_DJR on 08/20/2013 - 08:46

Hello Tonio,
Software packages prior to GalilTools are not supported in Win7. This includes all software pacakages on this page:
http://www.galilmc.com/support/software-downloads-legacy.php

For Windows 7 use, you will need to change your labview examples to use the GalilTools communication library instead:
http://www.galilmc.com/support/manuals/galiltools/library.html

You can see many LabView examples here (see table 1):
http://www.galilmc.com/learning/hellogalil.php

Since our introduction of the first microprocessor-based motion controller in 1983, Galil has remained a leading innovator. By offering our customers powerful, cost-effective and simple-to-use motion controllers and PLCs backed by superior application support, our commitment is to be the primary source for any motion control and I/O application.

Address:  270 Technology Way, Rocklin, CA 95765

Toll-Free:  (800) 377-6329 (US Only)

Phone:  (916) 626-0101

Fax:  (916) 626-0102

Email:  support@galil.com

2020 © Galil All Rights Reserved.